in

connecting users of the CorelDRAW family of products
CorelDRAW.com » Graphics Suite products » CorelDRAW X3 » flattening into indesign

flattening into indesign

Last post 06-25-2008 7:16 by steph_rhine77. 2 replies.
Page 1 of 1 (3 items)
Sort Posts: Previous Next

  • 06-25-2008 7:08

    flattening into indesign

    Reply Contact

    I am trying to convert a coreldraw manual into indesign and I am finding that I can't flatten it to be pasted into an Indesign file. Can anyone help to figure this out? thanks!!!!

    Stephanie 

    Stephanie

  • 06-25-2008 7:10 In reply to

    • Rikk Flohr
    • Top 10 Contributor
      Male
    • Joined on 06-29-2007
    • Apple Valley, MN

    Re: flattening into indesign

    Reply Contact

     I would use PDF as the go-between.  Output your Draw to PDF and bring the PDF into Indesign. Not an incredibly elegant solution but it will probably work.

    Rikk Flohr

    Fleeting Glimpse Images

    Photography Blog

  • 06-25-2008 7:16 In reply to

    Re: flattening into indesign

    Reply Contact

     convert the corel into pdf and then into Indesign? Will that work, and just save as ".pdf" then open in Indesign and save? in .indd?

    New to this, but thanks!

     

    Stephanie
Page 1 of 1 (3 items)
© 2008 Corel Corporation. CorelDRAW and the CorelDRAW Balloon are trademarks or registered trademarks of Corel Corporation. The content herein is in the form of a personal web log ("Blog") or forum posting. As such, the views expressed in this site are those of the participants and do not necessarily reflect the views of Corel Corporation, or its affiliates and their respective officers, directors, employees and agents. Terms and Conditions.